top of page

01 - servo cover
are a huge aesthetic step up from plastic servo covers.
The bulge is approx 1.5 mm deep and allows thicker servos in a narrow wing

04 - servo cover
cover used in IDS systems when the servo lever protrudes above the wing surfaces.

07 - Pushrod Exit cover
lightweight element made of carbon fiber.
weight only 0.15 gr
perfectly camouflages the tappet hole in the tail boom and more.

010 - antenna supports, output covers
the element allows for aesthetic exposure of antennas from a 2.4G hostile carbon environment.
it also allows you to maintain an optimal 90 degree antenna angle to increase range and avoid loss of control.
They offer these benefits:
Protect the antennas
Look cool
Reduce drag
Improve radio reception by keeping the antennas at 90 deg to each other.

015 - rubber antenna support
element made of polyurethane rubber, has an aerodynamic profile that reduces drag the antennas are fully secured because they are inside, gives the antennas an optimal angle of 90 degrees, virtually indestructible element easy to stick with standard rubber adhesives and UHU POR, UHU HART. available in black and red

02 - servo cover
The bulge is approx 4,5 mm deep and allows thicker servos in a narrow wing

05 - servo cover
an element made of light fabric with a small bulge suggested for DLG models and more

08 - Pushrod Exit cover small
lightweight element made of carbon fiber.
weight only 0.08 gr
perfectly camouflages the tappet hole in the tail boom and more.
suggested for DLG models and more

011 - Large Servo Cover With Bulge

designed for larger models with standard size servos

012 - large servo cover designed for larger models

 014 - cooling air inlet
indispensable element where the engine and the regulator heat up too much

016 - servo cover
servo guard with elongated pusher cover

018 - Servo Covers Blistered- reduced air resistance

03 - servo cover
standard servo  cover without bulges

06 - flat carbon plate

90mmx120mmx0.26mm

09 - Glider Tailplane Mount
a new professionally handcrafted strong and lightweight element. fits any sailplane with a tailboom. it is quite flexible where it sticks to the pipe, therefore it is suitable for pipes from about 12mm to 19mm. weight about 3 grams. to better align the element with the horizontal tail profile, I do not glue the top support plate.
the item is shipped in two parts

013 - antenna covers supports guide

an element made of crystal clear plastic, has an aerodynamic profile that reduces resistance

 the antennas are fully protected because they are inside,

 gives the antennas an optimal 90 degree angle,

 easy to stick

price for a pair

017 - DLG tailplane mount
light and durable element, additionally reinforced at the point of attachment of the horizontal tail. weight 1,3 g

019 - servo cover with a large hill

020 - DLG Throwing Blade

167874194_277710617241098_61473584767330
bottom of page